Sara-Clean is designed to specifically clean your timber surfaces in a gentle manner. It is available in powder form – a white granulated powder which is dissolved in water to form a solution. Sara-Clean will restore and clean your uncoated timber surfaces. It will not harm plants or rubber, and will not bleach clothing.
The Sara-Clean solution is a non- flammable, non-hazardous, biodegradable solution.
Instructions for use:
Add the entire packet (100 grams) of powder into 10 litres of clean water.
Saturate the surface to be cleaned with the ‘made-up solution’.
KEEP THE SURFACE WET FOR APPROXIMATELY 20-30 MINUTES THEN WASH OFF WITH WATER.
Ten litres of made up solution will clean approx 60-70 square metres of timber surface.
Once the Sara-Clean has cleaned the timber, it must be power water rinsed (at approx 600-800 psi pressure). Clean from the highest point and work down methodically allowing the water to cascade over the unwashed surface to keep it from drying out.
When cleaning soft timber surfaces, reduce jet pressure to avoid scouring of sapwood. ALWAYS clean off with a soft ‘even fan-shaped water jet’. DO NOT use ‘turbo jets’ on timber or paint work. For Accoya and other soft timbers, use a brush or broom instead.
Sara-Clean is slippery when applied to timber – do not walk on surfaces coated with Sara-Clean.
Water flush all equipment, vegetation, paths, concrete, asphalt and other adjacent surfaces immediately upon contact. Be aware of wind drift when applying and washing Sara-Clean off.